Beckhoff KL3356, Documentation

Page: 31 / 55

KS2000 Configuration Software
KL3356 31 Version: 2.3.0
Manufacturer scaling active ( R32.1 [ } 47] )
You can activate manufacturer scaling here (default: disabled).
Scale factor active ( R32.8 [
}
47] )
You can deactivate the scale factor here (default: enabled).
Watchdog timer active ( R32.2 [
}
47] )
You can deactivate the watchdog timer here (default: enabled).
Cyclic calibration enabled ( R32.4 [
}
47] )
You can deactivate cyclic calibration here (default: enabled).
Cyclic reference measurement enabled ( R32.6 [
}
47] )
You can deactivate cyclic reference measurement here (default: enabled).
Cyclic test enabled ( R32.5 [ } 47] )
You can deactivate cyclic testing here (default: enabled).
Symmetric reference potential ( R32.7 [
}
47] )
You can deactivate the symmetric reference potential here (default: enabled).
Stabilization of calibration active ( R32.9 [
}
47] )
You can deactivate the stabilization of the calibration here (default: enabled). The stabilization of the
calibration can be parameterized via the parameters "number of stable measured values" and "tolerance for
measurement stability".
Resolution of nominal parameter 0.01 mV/V ( R32.11 [
}
47] )
Here you can enable a resolution of nominal parameter of 0.01 mV/V, instead of the resolution of nominal
parameter of 1 mV/V (default: disabled).
After calibration wait for stable value ( R32.12 [
}
47] )
Here you can specify that, after calibration or measurement of the reference voltage, the KL3365 should wait
until the weight value output is stable before outputting the measured value (default: disabled).
Register data
Nominal weight ( R35 [
}
48] )
You can specify the nominal weight of the connected load cell here in kg (default: 5 kg).
Nominal parameter ( R36 [
}
48] )
You can specify the nominal characteristic value of the connected load cell here (default: 2 mV / V).
Scale factor ( R38 [ } 49] )
You can specify the scale factor here (default: 1000).
Measure interval for the reference signal ( R39 [
}
49] )
You can specify the measuring interval for the reference signal here in steps of 100 ms (default: 360 s).