Installation
3.3 Connecting devices
The power supply plug must be withdrawn
Attention
Please read the documentation for the external devices prior to connecting them!
During thunderstorms, plug connector must neither be inserted nor removed!
When disconnecting a plug connector, always handle it at the plug. Do not pull the
cable!
CU8803-0000 disconnect power supply
Attention
If using the CP-Link 4 - One Cable Display Link , the 24 V power supply of the
CP-Link 4 transmitter box must be switched off before disconnecting the CP-Link 4
output connection.
3.3.1 Connecting cables
The connections are documented in the section
When connecting the cables to the CU8803-0000, proceed according to the following sequence:
•
Switch off all the devices that are to be connected
•
Disconnect all the devices that are to be connected from the power supply
•
Connect all the cables between the CU8803-0000 and the devices that are to be connected
•
Reconnect all devices to the power supply.
3.3.2 Connecting Power Supply
1. Check that the external power supply is providing the correct voltage.
2. Connect the unit to your external 24 V
DC
power supply.
CU8803-0000
11
Summary of Contents for CU8803-0000
Page 2: ......
