Installation Instructions
10
C9900-P223 / C9900-P224
External wiring
The external wiring consists of the connection of the power supply, the
battery pack (only C9900-P224) and the connection of customized
components for shutting down the PC.
The external wiring occurs according to the wiring diagram, see chapter
Wiring diagram
.
Cable Cross Sections
Note cable cross sections,
avoid voltage drop!
For the connection of the power supply, wiring with a cable-cross-section
of 1.5 mm
2
must be used.
With bigger distances between voltage source and PC, you take the
voltage drop as a function of the cable-cross-section as well as voltage
fluctuations of your distribution voltage into account, so that is secured that
the voltage doesn't fall under 22 V at the power supply.
Insert fuse
Attention
The power supply must be protected with 16 A.
PC_ON and Power Status functions
If
the
PC_ON
input is connected to 24 V via a switch, the PC shuts
down according to the rules. The PC_ON signal is inverted, i.e. the
PC shuts down if the 24 V connection is live.
If
the
PC_ON
input is
NOT
connected by the user, the PC can be
booted in the familiar way by connecting the supply voltage and shut
down via the battery by switching off the supply voltage.
Service life of the rechargeable battery
Attention
This procedure significantly reduces the service life of the rechargeable
battery and should therefore not be used.
Once the PC has shut down, the
Power Status
output is switched
from 24 V to 0 V. Via this output a signal lamp can be connected or a
contactor for de-energizing the whole system. The maximum load for
the
Power Status
output is 0.5 A and a suitable fuse should be
provided.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
