Commissioning
CP37xx-1600
23
Version: 1.1
4. Gradually remove the film from the backing. At the same time, use a doctor blade or other object with a
soft rubber or felt edge to apply the film.
5. Brush away air bubbles towards the edge with a doctor blade or other object with a soft rubber or felt
edge.
ð
The film is now fitted.
Commissioning
In order to use the Panel PC, you must first commission it. The first step is to transport the device to is
operating location and unpack it. This is followed by the mounting of the device on the mounting arm, the
connection of the cables and the power supply and finally the switching on of the Panel PC.
4.1
Transport and storage
The specified storage conditions must be adhered to (see chapter 9
Despite the robust design of the unit, the components are sensitive to strong vibrations and impacts. During
transport the device must therefore be protected from mechanical stress. Appropriate packaging of the Panel
PC, in particular the original packaging, can improve the vibration resistance during transport.
NOTE
Hardware damage due to condensation
Unfavorable weather conditions during transport can cause damage to the device.
• Protect the device against moisture (condensation) during transport in cold weather or in case of ex-
treme temperature fluctuations.
• Do not put the device into operation until it has slowly adjusted to the room temperature.
• Should condensation occur, wait for about 12 hours before switching the device on.
Unpacking
Proceed as follows to unpack the device:
1. Check the packaging for transport damage.
2. Remove packaging.
3. Keep the packaging for possible future transport.
4. Check your delivery for completeness by comparing it with your order.
5. Check the contents for visible shipping damage.
6. In case of discrepancies between the package contents and the order, or in case of transport damage,
please inform Beckhoff Service (see Chapter 10.1
).
