Beckhoff C6925, Manual

Page: 22 / 47

Commissioning
C6925 22 Version: 2.1
4.2.2 Installation in the control cabinet
NOTE
Extreme environmental conditions
Extreme environmental conditions can cause damage to the device.
• Avoid extreme environmental conditions.
• Protect the device against dust, moisture and heat.
• Do not cover the device's ventilation grille.
When installing in the control cabinet, note that there must be 5 cm of free space above and below the
device for ventilation.
Mounting via mounting plates
In order to mount the Industrial PC by its rear or side panel in the control cabinet using the mounting plates,
the control cabinet must be equipped with drill holes for the fastening screws corresponding to the
dimensions of the PC (see chapter 4.2.1
Dimensions [
}
21] ). You need M4 screws for mounting.
After you have drilled the holes for the fastening screws in the control cabinet, you can mount the Industrial
PC in the control cabinet with the mounting plates.
Fig. 12: C6925_Control cabinet installation
To install the Industrial PC in the control cabinet, follow the steps below:
1. Place the fastening screws in the drill holes in the rear panel of the control cabinet.
2. Hang the PC on the screws at the marked places on the mounting plate (see fig. 12).
3. Tighten the fastening screws.
ð You have successfully installed the Industrial PC in the control cabinet.