Setting the limit positions
Attention
The programming unit is only designed for the commissioning, not for continuous opera-
tion.
Intelligent installation management
Completion of installation following automatic setting of limit positions
The drive saves the limit position setting permanently once the upper limit position is reached 3 times in succession and then the
lower limit position is reached 3 times in succession directly afterwards. Installation is then complete.
Upper stop to lower stop
Use of tubular drive of type RO+ possible both when using attachment springs and anti-lifting device.
Use of tubular drive of type RO possible only when using attachment springs.
The limit position becomes fixed after the tubular drive has turned off automatically in the desired position three times.
Note on roller shutter use
If the tubular drive switches off prematurely while opening or closing, due to an obstruc-
tion, the obstruction can be cleared by reversing a short way and removing the obstruc-
tion. The desired limit position can be set by opening/closing again.
Attention
Compliance with the following order for setting the limit positions is essential.
Open to the permanent upper stop.
Then close to the permanent lower stop.
The limit positions are now set.
Deleting the limit positions with a rotary switch or a locking button
The switching commands sequence must be carried out in quick succession.
Carry out the following deletion sequence without interruption between the individual drive commands:
STOP
1 s
until
1 s
1 s
1 s
1 s
1 s
1 s
The tubular drive makes a “click click” sound to confirm.
Both limit positions are deleted.
12
