Becker P9/16PS, Assemble And Operating Instructions, Page: 6 / 16

6
Assembly and Operating Instructions
5
6
7
• For profile tubes:
For some drive adapters, tolerances of the channel widths in different
roller tubes can be balanced by turning the drive adapter in a different
channel slot. These channel slots come in different sizes and make it an
exact fit possible when the drive is installed (Fig. 5).
• For round tubes:
Release the tube from the motor died in advance, so that the
cam of the ring can also be inserted into the tube. The cam of
the ring must not engage with the tube. For rings without pull-
ing cams, the roller tube must be connected to the ring by a
4.8 x 10 mm sheet-metal screw (Fig. 6).
4. Assemble the tubular drive with the relevant ring (A) and drive adapter (B).
Insert the tubular drive with the pre-assembled ring and drive adapter into
the tube as shown. Ensure that the ring and drive adapter are correctly
positioned in the tube (Fig. 7).
The drive adapter of the tubular drive is connected to the roller tube as
follows:
Attention
When drilling into the roller tube, never drill near the tubular
drive!
The tubular drive must not be hit into the tube or dropped into
the roller tube!
The drive manufacturer also recommends screwing the opposite end
bracket to the barrel.
5. Hang the tube in the bracket and secure the motorhead piece in the drive
bracket.
6. Hang the mounted unit consisting of tube, tubular drive and thrust bracket
in the bracket.
Size of drive
[mm]
Tubes–Ø
[mm]
Torque max.
[Nm]
Fastening screws
for drivers (4 x)
Ø 35
40 mm plastic drive
adapter
13
flat-headed sheet-metal
screw ST 4.8 x 10 DIN 7982