BEC MV200Z, Initial Setup Manual

Page: 6 / 10

Additional Information
Device Faults___________________________________________________________________
Each device for your system is supervised by the MV200Z console. The devices send out a
supervisory signal every hour that checks in with the console. If a supervisory signal is not seen
for a device within the programmed fault window (default 18 hours), then the MV200Z will
display a Device Fault alarm for that device.
Common Causes for Device Faults

Dead battery
o
Fix: Replace battery.

Device has left the facility.
o
Fix: Return device to facility or replace with a new device. Ensure the correct ID
of the new device is programmed in place of the old device.

Incorrect ID has been programmed in.
o
Fix: Check to see if the physical device ID matches the programmed ID for that
device.

Antenna has been disconnected from the MV200Z console.
o
Fix: Attach antenna to the back of the MV200Z console.

Device has been damaged.
o
Fix: Replace with a new device and ensure that the correct ID of the new device
is programmed in place of the old device.
After checking and fixing these common causes for faults, alarm the device to clear the fault
from the MV200Z console. If none of these options clears the fault, please call Systems
Technologies Technical Support at (208)-762-6800 for further assistance.