Bebecar Spinner 0986, Instructions Manual

Page: 13 / 32

ENGLISH
Make sure that both ISOFIX connectors are securely attached
to their ISOFIX anchor points. The colors of the indicators on
the both ISOFIX connectors should be completely green
(Fig. 11.1).
Check to make sure the base is securely installed by pulling on
the both ISOFIX connectors.
• The completely assembled base is shown as (Fig. 12).
The ISOFIX connectors must be attached and locked onto the
ISOFIX anchor points (Fig. 12.1).
The support leg must be installed correctly with green indicator
(Fig. 12.2).
• Please refer to rearward facing and forward facing in section to
use the child restraint.
• To remove the child restraint, turn the ISOFIX connectors
switches off and the indicators will be red, meanwhile you will
hear the “click”- sound, the ISOFIX connectors will be bounce
off and then can be removed from the anchorage system of
vehicle seat (Fig. 13). The ISOFIX is folded completely.
Reference age: Newborn to 4 years old
Recline position: Position 1
There is only reclined position and without upright position when
installing for children weighting 0-13 kg.
Please install the child restraint on the vehicle seat, then put the
child in it. Squeeze child restraint rotate release button (Fig. 25),
turn the child restraint to backward position (Fig. 26-27), and you
can hear a "click-sound”.
We recommend using the full inner pads while the baby
is 0-6 months or until they outgrow the pads. The inner
pads increase side impact protection (Fig. 14).
After the child is placed into the seat, check whether the
shoulder harnesses are at proper height.
• Push down the webbing adjuster button (Fig. 15.1), while
pulling out the shoulder harnesses to the proper length
(Fig. 15).
• Press the red button to disengage the buckle (Fig. 16).
• If necessary, place the small child inner pads in the child
restraint and thread the shoulder harnesses, waist harnesses.
• Leave the harnesses on the left side and right side respectively
(Fig. 17).
• Place the child into the child restraint and pass both arms
through the harnesses (Fig. 18).
NOTE: After the child is seated, recheck whether the shoulder
harnesses are at the proper height.
• Engage the buckle (Fig. 19).
• Pull down the adjustment webbing and adjust it to the proper
length to make sure your child is snugly secured (Fig. 20).
NOTE: Make sure the space between the child and the
shoulder harness is about the thickness of one hand (Fig. 20).
Using the Child Restraint
Rearward Facing Mode -
for Child under 18kg / Newborn - 4 years old
NOTE:
NOTE:
Securing your Child in the Child Restraint Rearward Facing
ISOFIX