L/R
Assemble left and right
side the same way
Note: all holes (2 holes)
on the surface of the top
of the wing are pre-drilled
at factory.
RIGHT
WRONG
5/64”
2mm
2.mm drill bit
Aluminum
tube inside
3x15mm screw
TOP
1
2
3x15mm screw
.........2
Secure the wing in place
using 3x15mm screw.
18- Wing Joiner / Flachenverbinder
Note: Cut out the stickers and apply them in the proper area.
Do not peel the backing paper off all at once.
Peel off one corner of the backing and cut off with scissors.
Arrange sticker on model and when satisfied adhere the
corner without backing.
Carefully peel back the rest of the backing while at the same
time adhering the rest of the sticker.
Try not to make air bubbles, if there are some, carefully
puncture sticker (center of bubble) but not model surface
with the tip of the knife or sharp pin and squeeze out the air.
At curves stretch sticker and apply a little heat so that no
ceases occur.
Cut off the excess that is produced.
19- Decor / Aufkleber
Linkage Stopper set
.................4
Note: All holes on the bottom of the wing and
holes on the side of the fuselage are pre-drilled
at factory.
3x3mm
set screw
CA
1
2
3
4
1
2
3
4
VQA064
(Kenmore Air version)
Slide the wing halves onto the
aluminum tube until the they are
meet the side of the fuselage
(if the fit is overly tight, it may be
necessary to lightly sand the
wing roots).
