beautyrest smart motion base 1.0, Owner'S Manual, Page: 15 / 28

13
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
syncing two bases
Unplug base from power source.
Disconnect the power-down box cable from splitter
cable. Make note where the cable was plugged in
Connect the male end of the sync cord to each splitter
cable. Insert it into the same port you disconnected the
power-down box from in Step 2.
If simultaneous operation of two bases is desired, use the SmartSync™ Cord
to connect the electronics of both bases together.
Connect each power-down box male connection to the
sync cord female connection (Refer to the illustration
below).
Plug base back into the power source.
Check to ensure all cords are securely attached. Both
remotes will now operate both bases simultaneously (If
the remotes become unpaired, see page).
Sync Cord
Control Box
Control Box
Power-Down Box
Power-Down Box