Ch. 3 Installation Tool
Remote Unit Installation
Installation Tool Operation
Service Utilities
24
Pre-Production
1106333-01
Revision 3
Step 3
Status Check
Note
:
You must enable the
Perform Manual Activation
check box or the
utility will revert to the automated self-install routine.
This step reads certain data from the remote unit and displays it in the
window. It also initiates a self-test and displays the results.
This step is where you access the BRU Configuration window. See the
section
on page 14 for a discussion of the BRU
Configuration window parameters and the service order file. If the remote
unit has failed to connect with a base station, verify the parameter values
in the BRU Configuration window as described below.
This step is also where you upload a new software image file. See the
section below for instructions.
The
Error Details
and
Help
buttons are not functional at this time.