Ch. 1 Introduction
Remote Unit Installation
BRU-150 Transceiver Features
Service Utilities
6
Pre-Production
1106333-01
Revision 3
BRU-150 Transceiver Features
This section introduces the physical features of the displays and
connections on the BRU-150 Transceiver.
The BRU-150 is designed for the subscriber, so its displays and controls are
designed for simple functionality.
Figure 1-2
Transceiver Front Panel
SIGNAL
STRENGTH
AIR LINK
SYNC
LEDs illuminate progressively
from the bottom up as the
signal strength increases.
Each LED also has three stages:
· Slow blink at lowest signal
· Fast blink at medium signal
· Solid at highest signal
Solid green when
authentication completes.
Red while unit is booting up.
Flashing amber while unit auto-searches
for a base station.
Solid green when synchronization and
ranging completes.
Flickers green when data is being passed.
Solid amber if synchronization did not
complete.
Default configuration button
recessed behind front panel.
· Cycles power to the unit
· Sets IP address to 192.168.1.1
· Sets subnet to 255.255.255.0
· Sets BSOC to -1
Use a paper clip or
similar object to actuate
the reset button.
ID
U
001
Flickers green when data
is being passed.