6
Part No. 6-847703-00 Rev. C00
Installation
Figure 2
WARNING:
Do not attempt to lift manifold alone. Two people
are recommended in order to hang manifold onto
wall mounting bracket.
4. Place bracket flat against wall as shown in
Figure 2 and align top of bracket with level
horizontal line. Vertical center line of bracket
will be vertical center line of installed manifold.
Mounting top of bracket at 79-3/4" height will
net a 61" height from center of manifold
control inlets to finished floor.
5. Mark locations of mounting holes. Remove
bracket and drill mounting holes. Attach
bracket to wall with appropriate anchors (by
others). 3/8" diameter anchors are
recommended.
6. Hang manifold control panel on mounting
bracket. Top two control panel mounting bolts
will slide into slots of bracket. Bottom of
manifold control panel should be angled away
from bracket until top two bolts have been
inserted as shown in Figure 3. Bottom of
control panel can then be positioned toward
bracket so 3/8" mounting stud passes through
lower hole in mounting bracket. Install and
tighten 3/8" nut removed in step 2.
