2
2.
Installation Setup
2.1
Install KV-901T Transmitter
1.
The DVI input of the KV-901T is
[DVI-I]
(VGA + DVI-D). You can
use the accessory of VGA-to-DVI cable to connect KV-901T to
PC VGA-Out. Or you can prepare a DVI-to-DVI cable to connect
KV-901T to PC DVI-Out.
2.
There is a
[VGA-Out]
on the KV-901T for the VGA loop-out. It is
only available when the input video is DVI-A (or VGA). You can
attach a VGA monitor on this
[VGA-Out]
for local display.
3.
Use accessory of audio cable to connect KV-901T
[Line-IN]
to
the PC Line-Out.
4.
Use optional accessory of Mini USB-to-A cable to connect KV-
901T
[Mini USB]
to PC USB for keyboard/mouse remote control.
5.
Use optional accessory of IR blaster cable to connect KV-901T
[IR Out]
and adjust the IR blaster LED face to the IR receiver of
your Media Center PC, TV tuner card or DVD player.
6.
Use CAT5e/6/7 cable to connect KV-901T
[Ethernet]
to the
Ethernet switch (or directly to the AV-901R). All of KV-901T and
AV-901R must be put in the same network and should not be
inter-connected with router.
7.
Use the included 12V DC power adapter to connect KV-901T
[DC IN]
power socket and plug the power supply to wall.
8.
There is a [Status] LED and 2 RJ45 LEDs on the KV-901T, please
refer to the below table for the status of KV-901T:
[Status] LED
RJ45 LED
Status
Red
Green
Green
Orange
On
System OK, network is not connected
Blink
On
System software trap error
On
Blink
System OK, network is connected
On
On
On
System OK, transmit rate exceeds 50Mbps
On (
Orange
)
On
LED shows as indicated when [Reset] button is
pressed, and it stays on until system reboots.