11
Step 4:
Release the [Reset] button when you see the
[Status]
(or
[Power]
) LED starts blinking red.
Step 5:
After the
[Reset]
button is released, in case of AV-901R,
the
[Power]
LED will become orange; in case of KV-901T,
the
[Status]
LED will become orange blinking. This
indicates the device is entered Setup Mode and you can
start to setup and get access to the HTTP server of the
device. If you are not in this status, any setup process is in
vain.
Step 6:
Use a straight Ethernet Cable to connect the PC with the
device. (The
[Status]
or
[Power]
LED is still lit in orange.)
Step 7:
Ping the connected device through the sequence, Start,
Run, cmd, ping [TX IP] or ping 192.168.168.22 (for RX). If
you receive the reply, it means the device is ready for
setup mode. Use IE browser to open the setup page. For
AV-901R, the URL is
http://192.168.168.22
. For KV-901T,
the URL is
http://[TX IP]
. In this page, you can change IP
address, subnet mask, gateway, device name, network
protocol and destination.
Device Name
:
the name of the device.