too much water on display
installation error messages
Upon connecting the
ET-
1000 to your spa system
,
you may see one of two error messages. Please follow
the instructions in the message or contact your dealer
or contact Beachcomber Technical Support
at 1-800-663-6557 (press
4
for tech support)
electrical configuration
Please do not make changes in this
section unless you are a qualified
electrician.
about your
hot tub
system
about
To get info about your
hot tub
system, slide
the right wheel until the about icon is
highlighted in the middle.
Information about the ET-1000 software
number and the revision numbers of the
components of your system will be
displayed.
wipe screen
This message appears when too much
water is detected on the touch screen.
Simply wipe away excess water.
diagnostic
error
display messages
Please follow the instructions in the message or contact your dealer
or contact Beachcomber Technical Support
at 1-800-663-6557 (press
4
for tech support)
WARNING! DO NOT ENTER SPA
High Limit circuit has tripped!
FLO condition - Check filter,
pump, blockage, air lock and water level
Persistent NO FLO, all off - Check filter,
pump, blockage, air lock and water level
DANGER! DO NOT ENTER SPA
Hardware error detected (relay stuck)
WARNING! DO NOT ENTER SPA
Spa temperature is too high
WARNING! DO NOT ENTER SPA
Temp probes/detect. circuit defect.
ERROR
Elevated internal temperature
DANGER! DO NOT ENTER SPA
Hardware error detected (thermal fuse)
The spa pack does not have valid software.
Please insert valid in.stick to reprogram spa pack
HL
FLO - L01
FLO - L02 FLO
NO FLO
HR
OH
Prr
AOH
Hr
UPL
code
displayed error message
6
