Beaba 920290, Instructions Manual

Page: 11 / 92

10 11
3. Place the adjustable feet (c) in the rails (h) according to the diagram below.
h h
c
c
c
The slope must
always be tur-
ned towards the
exterior of the
changing table.
4. Position the changing mattress (b) on the table. Pass the strings through
the casings at the rear of the table and tie a knot to attach the mattress.
CAUTION: Always check that all the parts are fastened properly
before using the product.
USING ON A BATH
• Always check that the suction cups are fastened properly.
• Always clean the surface and wet the suction cups before positioning.
• Always check that the bath’s dimensions are suitable for the changing
table before positioning it.
Place the product on the bath ensuring that the adjustable feet (c) are inside
the bath.
Check that the changing table is compatible with the bath’s dimensions and
shape.
42 cm mini - 63 cm maxi
5 cm mini
d e
Attach the rear suction cups (e) to the edge
of the bath. Then adjust the front suction
cups (d) so that they are centred on the
front edge of the bath. Check that the 4
suction cups are positioned properly by
trying to lift the product. It should not be
possible to remove the changing surface.
c
Adjust the 3 adjustable feet (c) so that
they rest against the sides of the bath.
Check that the feet are adjusted properly
by pulling the changing table towards you.
Notice Plan CameleO 2015 105X150 v2.indd 11 06/11/2015 10:27