x
+
-
12-24 V DC
COM
NO
COM
NC
*
*
CLASS 1 LASER PRODUC
T
CLASS 2 LASER RADIATION
DURING INST
ALLATION.
DO NOT STARE INTO BEA
M
IEC 60825-1
1
2
3
3
ON
OFF
> 3 sec.
INSTALLATION
DIP SWITCH
DIP 2 ENVIRONMENT
DIP 3 BACKGROUND
DIP 4 MONITORING
standard
critical*
DIP 5 WORK MODE
DIP 1 OUTPUT CONFIGURATION
NO/NC
NO/NO
POWER SUPPLY
** TEST / MONITOR
R1(RELAY)
R2(OPTO)
GREEN
BROWN
YELLOW
WHITE
PINK
GREY
RED
BLUE
Output status when the sensor is operational
without detection.
The safety field responded relay will switches
automatically to output status with detection
during the remote control access.
Only the safety field responded relay would
respond for the test.
INSTALLATION OF THE SENSOR
Install the sensor at the right position and fix it with the screws.
* When DIP2 is OFF (critical environments),
testbody
CA
(EN 16005) might not be detected.
Switch to CRITICAL when external disturbances are
likely to cause unwanted detections.
Switch to OFF when there is no background
(e.g. glass floor).
Make sure the front side of the sensor faces towards the
outside of the door.
Install the sensor in the canopy of the door above the
area to be protected by safety.
WIRING
After changing a DIP switch, the orange LED flashes.
A LONG push on the push button confirms the settings.
recommended position
front side
active high
JFS
active low
normal
ON
OFF
**
*
