4/8
1. INSERTION OF BATTERIES
•
Open the battery compartment at the back of the remote control;
•
Insert two AAA batteries supplied with the remote control as shown on the left;
•
Close the battery compartment.
0-9 Number keys (1)
Not used (2)
Plus (3)
Unlock (4)
Minus (5)
Holdtime (6)
Sensitivity (7)
Detection mode (8)
Immunity (9)
(10) Not used
(11) Not used
(12) Not used
(13) Mounting height
(14) Door control
(15) Check Values
(16) Lock
(17) Output configuration
(18) Not used
(19) Setup
(20) Not used
Note:
For optimum results point the remote control to the sensor
before pressing its buttons. The sensor can be adjusted with or
without its cover from a distance up to 5m.
2. CONFIGURATION OF THE SENSOR
Every adjustment session using the infrared remote control must start with unlocking and end with a double locking.
The table below lists the parameters able to be adjusted by remote control and the operations required in order to adjust these
parameters.
PARAMETERS
OPERATIONS
LED SIGNAL
UNLOCK
Press the
UNLOCK
key (4).
Enter your access code using
0-9
NUMBER
keys (1). The access code can be composed
of 1 to 4 digits (factory values or no access code: 0 or 0000).
During the first sensor adjustment or if the access code is reset to the
"0000" value
(factory setting)
or during the first minute after the power-on, press only the
UNLOCK
key
(4) (no access code required).
UNLOCK with access code of 4 digits
UNLOCK with access code of less than 4 digits
UNLOCK without access code
The red LED flashes quickly waiting for the
access code.
After entering the correct access code or if no
access code is required, the red LED flashes
slowly to indicate that the unlock was successful
and the adjustment session has begun.
Note.:
= Adjustment session ON
LOCK
When all the parameters have been set, press the
LOCK
key (16).
If you wish to enter a new access code, use
0-9
NUMBER
keys (1) to enter the new 4-digit
access code within 1 minute.
If no access code is entered or if you want to keep the current access code, press the
LOCK
key (16) once more.
If no remote control key is pressed within 1 minute, the adjustment session is automatically
locked.
LOCK with access code change
LOCK without access code or access code change
The red LED stops flashing and returns to its
normal function.
FUNCTIONS
CONFIGURATION
WITH REMOTE
CONTROL
