Page
8
of
16
75.5652.01
20100830
14
Confi gure BodyGuard III
BODYGUARD III
1. Unlock BodyGuard Sensor
2. Set Output Con
fi
guration to Normally Closed
3. Lock Sensor by pressing Lock twice
NOTE: You may or may not need to adjust the BodyGuard pattern width. For instance if you are using a one door system, you must set the pattern
to ‘Center Narrow’. However if you are using a two door system, the default BodyGuard pattern will suf
fi
ce. Please refer to BodyGuard User’s Guide
(75.5134) as necessary.
1
4
7
F1
F2
5
8
0
+
?
3
6
9
2
2
OUTPUT
CONFIGURATION
- Normally OPEN Relay (default)
- Normally Closed Relay
1
2
15
Check Function Number of Doors on DP-Hub
One door system:
1. Set ‘FUNCT’
Fd
to ‘INCR’
01
by
fi
rst pressing the ‘FUNCT’ button until DP-Hub display shows
Fd
then press ‘INCR’ button until display shows
01
.
Two door system:
1. Set ‘FUNCT’
Fd
to ‘INCR’
02
(default) by
fi
rst pressing the ‘FUNCT’ button until DP-Hub display shows
Fd
then press ‘INCR’ button until display
shows
02
.
NOTE: The above step for showing how to check and/or change a function is the same procedure for checking all functions listed in Section 6 -
Programming the DP-Hub. Please check all Programming Parameters in Section 6 before proceeding to Step 16 - Perform Door Learn. In
most applications, changing
Fd
will be the only necessary adjustment.
Fd = 01 Fd = 02
TWO DOORS
ONE DOOR
5 Installation (continued)
CAUTION: When using the remote control to adjust the Bodyguard, make sure you do not accidentally
change the settings on any other sensors.