10
11
CAUTION
Excessively high operating speeds increase risk of injury and damage to
water pump.
Excessively low speeds impose a heavy load.
• DO NOT tamper with the governed speed.
• DO NOT modify the water pump.
• DO NOT allow unqualified persons or children to operate or service
water pump.
NOTICE
Improper treatment of water pump can damage it and shorten its life.
• If you have questions about intended use, ask dealer or contact
nearest authorized dealer.
• Be sure pump chamber is filled with water before starting the engine.
Never run pump without priming.
• Use a non-collapseable hose on the suction side of the hose.
• Use water pump only for intended uses.
• Pumping sea water, beverages, acids, chemical solutions, or any other
liquid that promotes corrosion can damage the pump.
• Ensure all connections are air tight.
• DO NOT obstruct the suction or discharge hose in any way.
• NEVER operate pump without strainer basket connected to end of
suction hose.
• NEVER allow vehicles to drive over hoses. If a hose must be
positioned across a roadway, use planking on each side of hose to
allow vehicles to pass over without obstructing or collapsing hose.
• Anchor pump to avoid equipment movement.
• Keep equipment away from edge of river or lake where it could cause
the bank to collapse.
• DO NOT insert any objects through cooling slots.
• NEVER operate units with broken or missing parts, or without
protective housing or covers.
• DO NOT by-pass any safety device on this machine.
• NEVER move machine by pulling on hoses. Use frame on unit.
• Check fuel system for leaks or signs of deterioration, such as chafed
or spongy hose, loose or missing clamps, or damaged tank or cap.
Correct all defects before operating water pump.
SAFETY
Your unit may differ from the model shown
below. For specific model information, please
visit our website:
BEPOWEREQUIPMENT.COM
1. Fuel Tank
Fill tank with regular unleaded fuel. Always leave room for fuel
expansion.
2. Priming Plug
Fill pump with water here to prime pump before starting.
3. Discharge Outlet
Connect discharge hose here.
4. Choke Lever
Prepares a cold engine for starting.
5. Air Cleaner
Protects engine by filtering dust and debris out of intake air.
6. Recoil Starter
Used for starting the engine manually.
7. Engine Speed Lever
Used to adjust engine speed to control pump output.
8. On/Off Switch
Set this switch to “On” before using recoil starter. Set switch to
“Off” to stop a running engine.
9. Oil Drain
Drain engine oil here.
10. Oil Fill
Check and add engine oil here.
11. Suction Inlet
Connect reinforced suction hose here.
12. Water Drain Plug
Remove to drain water from pump
and flush internal
components with clean water.
13. Pump Chamber
Be sure to fill with water before starting.
14. Fuel Shutoff Valve
Used to turn fuel supply on and off to engine.
Item Not Shown:
Strainer Basket
Used to limit passage of abrasive materials into the pump.
WATER PUMP COMPONENTS
1.
2.
3.
12.
11.
7.
6.
13.
14.
9.
11.
4.
10.
8.
