16
Installation
Installing the car seat for children weighing
from 15 to 36 kg.
Securing the Pick Up car seat to the Isofix an-
chor points in your car.
Note: The Isofix safety standard was devel-
oped to ensure secure and easy fastening
of child restraint systems inside passenger
vehicles. Not all cars have Isofix anchor points,
although they are becoming more common.
Consult the attached list of cars in which it
has been verified that Isofix seats can be
correctly installed.
1. If your vehicle is equipped with Isofix an-
chor points, these should be used to obtain
a more stable installation.
These cars will have plastic elements that
guide the seat’s Isofix anchors into their cor-
rect positions. If your vehicle does not have
these guide elements, you can use the plastic
guides provided with the G Ofix car seat. (The
Isofix connector guides should be positioned
as shown in Figure 5).
Caution: When the seats of your car are
equipped with Isofix anchor points, install
your Pick Up car seat using your vehicle’s ISO-
FIX anchor points ALWAYS and ONLY in com-
bination with the car’s safety belts. See the
vehicle list.
2. Match the low-back rest hook to the rear
side of base from lying position to upright
position, to make sure the low-back rest is
fully matched into the base.
1. Place the Pick Up car seat in the appropri-
ate position on the vihicle’s seat, facing in the
direction of travel.
2. Rotate the adjuster button in anti-clock
wise direction, and simultaneously pull the
isofix connectors outwards as far as it goes,
make sure it cannot be push backwards (Figure 6)
3. Position the Pick Up car seat facing for-
wards on the vehicle seat with ISOFIX points.
4. Match the ISOFIX connectors to the vehi-
cle’s anchoring point until hear a “click” (Figure
7)
5. Rotate the adjuster button in anti-clock
wise direction, and simultaneously push the
seat against the vehicle to eliminate the gap
between Pick Up and vehicle’s seat.
ATTENTION!
ISOFIX connectors are an additional fitting
system for securing the Pick Up car seat and
not suitable for securing a child.
Children must always be secured by means of
the car’s three-point safety belt. Figures 6-7
REMOVING THE BE COOL Pick Up
To remove the Pick Up car seat, pull the grey
button backwards on the Isofix anchors to re-
lease the Pick Up from vehicle’s Isofix anchor
points. (Figure 8)
ATTENTION!
If you have difficulty to release the Isofix con-
nectors. Try to give a bit more force to the
Pick Up against the vehicle’s seat and simulta-
neously to pull the grey button backwards on
the Isofix connectors to release the Pick Up.
This may help, if not, please consult manufac-
turer or your retail stores.
Securing your child in the Pick Up car seat
1. Place your child in the Pick Up seat and
make sure they are sitting well back.
2. Thread the vehicle’s seat belt over the
child’s shoulder and the belt guide under
the armrest of the seat.
2.1. Pass the diagonal section of the seat belt
through the belt over the child’s shoulder,
make sure the belt us not touches to child’s
neck.
2.2. Pass the lap section of the seat belt
through the seat belt guide under the armrest
GB
Summary of Contents for PickUp
Page 8: ...8 1 2 3 4 5 6 7 8...
Page 11: ...11 Figure 9 Figure 11 Figure 12 Figure 10 Figure 13...
Page 30: ...30...
Page 31: ...31...