USER MANUAL
5
TROUBLESHOOTING
INSPECTION, STORAGE & TROUBLESHOOTING
INSPECTION
STORAGE
This device shall be inspected immediately if the device is believed to have been subjected to an abnormal
load or shock. It is recommended that this inspection be made by a manufacturers or supplier’s authorized
repair facility.
Owners and/or operators should be aware that repair of this equipment may require specialized knowledge
and facilities. It is recommended that an annual inspection of the product be made by a manufacturers or
supplier’s authorized repair facility and that any defective parts, decals, or safety labels or signs be replaced
with manufacturers or supplier’s specified parts.
Do not wrap the air line around the bottle jack as sharp edges may pierce or crack the air line. Coil the air
line when storing.
This Jack should be stored in a dry location on a level surface
SYMPTOM
POSSIBLE CAUSES
SOLUTION
Jack will not lift the load.
1. Release valve not tightly
closed.
2. Low oil level.
3. Defective or worn internal
parts.
4. Load exceeds maximum
allowance.
5. Air supply inadequate
6. Air trapped in system
1. Tighten release valve.
2. Check and add oil. Follow “Check
and Refill Oil” instructions on Pg.4.
3. Discontinue use and contact a local
repair center.
4. Use a higher capacity jack.
5. Ensure adequate air supply
6. Purge system (See Air venting
procedures pg. 4)
Jack will not hold the load.
1. Release valve not tightly
closed.
2. Power unit malfunction.
1. Tighten release valve.
2. Discontinue use and contact a local
repair center.
Jack will not descend to
minimum height, or will not
remain in lowered position.
1. Air trapped in system.
2. Reservoir oil overfilled.
1. Vent air out of system. Follow “Air
Venting Procedures” above.
2. Check and ensure proper oil level.
Follow “Check and Refill Oil”
instruction on Pg.4.
Jack will not lift to max
height.
1. Low oil level.
2. Air trapped in system
1. Check and ensure proper oil level.
Follow “Check and Refill Oil” on
Pg.4.
2. Purge system (See Air venting
procedures pg. 4).
Jack will not function
properly after tried solution.
1. Internal malfunction or
structural damage.
1. Discontinue use and contact an
authorized repair center.
Summary of Contents for 35.300.050
Page 8: ...8 USER MANUAL...
