13
BD DROP SAW
ASSEMBLY
CUTTING HEAD ADJUSTMENTS
(B)
Pivot adjustment bolts are located on
either side of cutting head vertical support
for adjustments or motor removal.
(A)
Two bolts are located under motor mount
plate to adjust stop plate for cutting head
stop height.
1. Check for damaged, broken, or missing parts.
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-660 Saw to a power supply, be sure the voltage, cycle
and phase of the job site power source meet the requirements of the table below:
(A) Ensure the ON/OFF Switch is in the OFF position
(B) Plug BD Drop Saw into the GFCI
(C) Plug the GFCI into the power source
VOLTAGE:
120v
CYCLE:
60hz
PHASE:
1-phase
BD DROP SAW SETUP FOR OPERATION
CAUTION
4. If using an extension power cord, make sure the length and wire gauge
correspond to the requirements listed in the table on page 8. An extension
power cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
5. Use an approved Ground Fault Circuit Interrupter (GFCI).
6. Do not cover the motor vents as this could lead to motor overheating.
NOTE:
NOTE:
In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
Barranca Diamond has available, as an accessory item, (Part # 152610) a plug-in GFCI
that may be plugged into a properly installed and grounded 3-pole outlet.
