Oil-Fired BCS
Page 11
COMPANY’S RESPONSIBILITY
The company’s responsibility is to repair or replace, at our option, with the prevailing compa-
rable Bock model, any part of the equipment, including the tank, sold by the company which
proves to be defective in material or workmanship during the warranty period, when installed
in accordance with applicable codes and ordinances, and operated and maintained in accor-
dance with our instructions, subject to the conditions and exceptions indicated below. Our lia-
bility, in the event of leakage or other malfunction, is strictly limited to repair or replacement
of the defective heater or part, as provided herein. We are not responsible hereunder for inci-
dental property damage or personal injury, consequential costs or damage. Equipment that is
repaired or replaced will carry the unexpired portion of the original equipment warranty.
BURNER AND CONTROLS
Any burner and/or controls used on a Bock water heater other than the ones recommended by
Bock Water Heaters,
and listed by Underwriters Laboratories, Inc., will void the water
heater warranty
. Bock Water Heaters specifies burners and controls on the basis of safety, re-
liability and performance. Only the following burners and controls have been tested and ap-
proved by Bock Water Heaters and Underwriters Laboratories, Inc., to meet the stringent
standards required by both:
20e-BCS: Carlin 0.4 x 60A; 32E-BCS: Carlin 0.75 x 70A;
40E-BCS: Carlin 0.85 x 70A; 51E-BCS and 120E-BCS: Carlin 1.1 x 70A;
190E-BCS: Carlin 1.35 x 70B.
The only controls acceptable for use with these models are as follows:
For normal household applications:
Burner: Carlin EZ1 with 15-minute post-purge and nozzle heater.
Temperature Control (aquastat): 20, 32, 40, 51E-BCS—Carlin EZ-Temp 90000B
120E-BCS—Carlin EZ-Temp 90000C, 90300B
190E-BCS—Carlin EZ-Temp 90300B
OWNER’S RESPONSIBILITY
At the company’s request, the owner is to return to the factory at Madison, WI, any part, in-
cluding the tank, defective in material or workmanship, and pay all transportation charges for
such return parts and for replacement parts sent from the factory to the owner. The owner will
pay all labor charges for the removal and installation of such parts, including the tank. Any
replacement water heater furnished under this warranty shall remain in warranty only for the
unexpired portion of the original warranty. The owner will have annual inspections of the
anode rods. Bock Water Heaters requires paid receipts to show maintenance of anodes on glass
lined tank claims.
EXCEPTIONS
This warranty will not apply to tanks or parts subject to misuse, abuse, neglect, alteration,
accident, excessive temperature, excessive pressure, lime, silt or sediment accumulation,
corrosive atmosphere, the removal of the magnesium anode rods, noise, odor, rusty water,
the installation of an insulation blanket, installation outside of the United States (excluding
Canada), or on which the serial numbers have been altered. The warranty also does not apply
when the water heater is installed without a new temperature and pressure relief valve and is
not installed in accordance with local codes and ordinances.
