5
EN
GL
IS
H
⑤ PRE OUT (RCA OUTPUT)
This output allows you to use the amplifier as a preamplifier
and Therefore connect a power amplifier to upgrade the
system.
⑥ OPTION (RCA INPUT)
Without Oponal card, this input works as a 4th LINE input.
If you use an Oponal Card, this RCA input will be disabled
in favor, for example, of the oponal Bluetooth card
allowing you to listen to your music from your Smartphone.
In that case, when you are selecng the Opon’s source
buon (in front panel), you can listen to music from your
Bluetooth device.
⑦ LINE 3 (RCA INPUT)
The LINE 3 input is for connecng a "line level" source. This
input has an opon "AV BYPASS" - [See # 10 in this manual
for more informaon].
⑧ LINE 1 & LINE 2 (RCA INPUTS)
The LINE 1 & 2 inputs are for connecng a "line level"
source to your amplifier. It is designed to receive an
"analog" signal (as opposed to "digital" signal). To connect
your source we are using a tradional "RCA" cable, they are
usually idenfied by a color code "RED" to the RIGHT and
"WHITE" to the LEFT channel.
Connecng a turntable:
Most turntables have output
format "RCA" but the signal is not compable with the "line
inputs" amplifiers. To use turntable, it is necessary to use a
"phono preamp" compable with a "reader cell phono".
There are 2 families of cells, MM (Moving Magnet) or MC
(Moving Coil). The most used cells among the public are in
MM format.
⑨ DAC - COAXIAL and OPTICAL INPUTS
This buon is acvang alternately the digital inputs RCA
and Opcal on the rear of the amplifier. It allows listening
to digital sources connected to the amplifier with the
integrated Digital to Analog Converter (DAC) compable
with all PCM stereo formats (up to 48 kHz).
Note:
You can leave connect two sources, one on the
Opcal input (LED is red), and the other on the Coaxial
input (LED is white) and acvate the one that suits you by
repeatedly pressing the DAC buon on the front panel.
⑩ AV BYPASS (ON/OFF) - COAXIAL and OPTICAL INPUTS
The LINE 3 input has an opon "AV BYPASS" which takes
you through the amplifier without using amplificaon part.
This is very useful if you wants, for example, connect your
speakers directly on another AV amplifier output.
① PHONE / HEADPHONES
Important note:
Make sure the volume control is turned
down before connecng or disconnecng headphones.
Listening at high levels can cause permanent hearing
damage.
This taken Jack size 6.35 mm allows connecon of stereo
headphones. It is advisable to use a listener with an
impedance between 32 and 600 ohm headphones. When
the headset is connected, the output to the speakers are
then cut.
② STANDBY ON (SLEEP MODE)
his buon allows you to turn the device in Sleep mode to
conserve energy while not performing his primary funcon
or to resume the device in acve mode.
Connecons (rear panel)
Front panel
Connecons and uses
Front panel
