4
- Some countries do not allow the exclusion or limitaon of
incidental or consequenal damages or exclusions of
implied warranes. Therefore, the limitaons or exclusions
herein may not apply. This warranty gives you specific legal
rights, in addion to other rights which vary from state to
state or country to country.
Make sure that the device is not plugged into the mains
before making any connecons. It is also recommended to
turn off or disconnect all other devices associated while
making connecons to the product.
Connect the speakers to the speaker jacks on the back and
the sources of the corresponding input jacks on the back.
Connect the power cord to the connector on the one hand
AC Mains product and the other to a wall outlet.
Turn the POWER switch acve (on the ON posion) - [page
5, buon
⑫
under the amplifier].
If the unit is equipped with a standby, then press the
STANDBY buon to turn it on.
Press the input selector for the source you want to hear.
Warning:
Be sure to turn off the power switch on your
product before making any connecons. Similarly it is best
to cut the power of the other devices you want to connect
to your amplifier.
Be sure to turn off the power on your product before
making any connecons. Similarly it is best to cut the power
of other devices you want to connect to your amplifier.
① TRIGGER OUTPUT
This 3.5 mm Jack mono output is used to acvate or
desacvate remotely auxiliary devices connected to the
amplifier. When the unit is turned on, the output is
switched to 12V. When the unit is turned off, the trigger
output is 0V.
② AC MAIN INPUT
Once all connecons to the amplifier, plug the power cable
into an outlet and turn the unit on. Your amplifier is now
ready for use.
③ LOUDSEPAKER TERMINALS
Connect the speaker to the terminals marked RIGHT "+ R"
and "R -" ensuring that "R +" is connected to the "+"
terminal of the enclosure and "R -" is connected to the
terminal "- "the same enclosure. Connect the LEFT speaker
to the terminals marked "L +" and "L -" by doing the same.
Make sure that no wires are not insulated can bypass the
speaker outputs. Make sure that the speaker terminals are
ght enough to ensure a good electrical connecon. If the
terminal screws are not ght enough, the sound quality
may be affected.
Use only dedicated wire to the speaker (a secon of 1.5
mm² or more is recommended especially if the cable length
is greater than 3m).
Important Note:
Check the impedance of your speakers.
When using a pair of speakers, you can use speakers with
an impedance of between 4 and 8 ohms.
④ OPTIONAL BOARD CARD
This slot allows you to add, when you want, one of the
Oponal cards for adding one more source, like a digital
card that lets you listen to music from a computer.
Basic instrucons
Quick starng guide
Warranty
Connecon to the amplifier
Rear panel