GSS3219B
Owner’s Manual
12
Step 12 (Side burner assembly)
a) Open the side burner lid and place
the side burner frame (O) on the
right side shelf. Make certain the
venturi tube is connected properly
with valve.
b) Align the four holes on the side
burner frame (O) with the four holes
on the right side shelf. Insert one
bolt (CC) into each hole and place
one flat washer (GG), one spring
washer (HH) and one nut (II) onto
each bolt from the bottom of right
side shelf, tighten all bolts by hand.
c) Connect the side burner ignition wire
by sliding it onto the electrode on the
side burner frame (O).
d) Go back and tighten all bolts using
the screwdriver provided.
Step 11 (Side knob & seat assembly)
a) Align the holes on the side knob bezel
(N) with the holes on the right side
shelf and the side burner valve. Screw
one M4x10mm bolt (DD) with one flat
washer (GG) into each pre-drilled hole
by hand.
b) Tighten the bolts using the screwdriver
provided.
c) Insert the side knob (M) onto the valve
shaft.
DD
M4X10 Bolt
2 PCS
GG
M4 Flat Washer
2 PCS
CC
M4X15 Bolt
4 PCS
GG
M4 Flat Washer
4 PCS
HH
M4 Spring Washer
4 PCS
II
M4 Nut
4 PCS
