GSF2818KMN
Owner’s Manual
10
Step 13 (Side burner assembly)
a) Open the side burner lid and place the right side burner assembly (U)
onto the right side shelf (V) and place the left side infrared burner
assembly (B) on to the left side shelf (D). Make certain the venturi
tube is connected properly with valve.
b) Align the four holes on the right side burner assembly (U) with the
four holes on the right side shelf. Insert one bolt (DD) with one spring
washer (GG) and one flat washer (FF) into each hole, tighten all bolts
by hand. Repeat the procedure on the left side burner (B).
c) Place the right side burner support (T) on the right side burner
assembly (U); place the left side infrared support (A) on the infrared
burner assembly (B), then close the side burner lids.
d) Connect the side burner ignition wire by sliding it onto the electrode
on the right side burner assembly (U). (See the right diagram).
e) Go back and tighten all bolts using the screwdriver provided.
Step 11 (Assemble the side shelves to the body assembly)
a) Loosen the three pre-installed bolts on the right side of body assembly and allow 1/4 bolt’s length to extend from body
assembly.
b) Align the holes on the right side shelf (V) with the bolts extended from the right side of body assembly. Push down the
right side shelf until it locks into place.
c) Align the holes on right side shelf with the holes on the control panel and body assembly.
d) Insert one bolt (AA) with one spring washer (CC) and one flat washer (BB) into each pre-drilled holes. (See above
diagram). Tighten bolts by hand until secure.
e) Repeat the procedure for the assembly of left side shelf (D) and body assembly.
f) Go back and tighten all bolts using the screwdriver provided.
Step 12 (Side knob & knob seat assembly)
a) Align the holes on the side knob seat (F) with the holes on
the right side shelf and the side burner valve. Screw one bolt
(EE) into each pre-drilled hole by hand.
b) Tighten the bolts using the screwdriver provided.
c) Insert the side knob (G) onto the valve shaft.
d)
Repeat the procedure on the left side shelf.
