background image

 

1. SAFETY WARNINGS 

INSTALLATION / SAFETY INFORMATION: 
READ AND UNDERSTAND THIS USER’S GUIDE COMPLETELY BEFORE INSTALLING OR 
USING THIS PRODUCT!!  

 

 

WARNING

: FIRE HAZARD, BURN HAZARD!!  Even quality electronics can fail CAUSING 

THE BLOWER TO RUN CONSTANTLY, RESULTING IN EXCESSIVE TEMPERATURES!  Power 
Draft Blowers can get the pit temperature higher than natural draft. Use extra caution in opening your pit.  
Always inspect your probe wire for damage which can cause the blower to run constantly causing the pit to 
become excessively hot. 
 

 

WARNING

: FIRE HAZARD, BURN HAZARD!!  FLAMES, SPARKS AND LIT 

EMBERS CAN EXIT ANY OPENING ON THE COOKER CAUSING FIRE - Keep the cooker located a 
safe distance from flammable objects including buildings, walls, solvents, cars, fuel, wood piles, furniture, 
etc. and use caution when opening the pit.  An ember that has fallen or is ejected from the cooker can be 
blown by a light wind into a garage or other structure, debris field, woods, or grass field and cause fire. 
Have a fire extinguisher and water supply available near the cooker.  If the cooker is used on a wooden or 
combustible surface such as a wooden deck, place the cooker on a non-flammable pad intended for this 
purpose. 
 

 

WARNING

: FIRE HAZARD, BURN HAZARD!!  Even quality electronics can fail and cause the 

temperature to read incorrectly. Use a redundant dial thermometer as a backup temperature sensor to verify 
the control’s reading of the pit temperature.    
 

 

WARNING

:  SMOKE CAN COMBUST WHEN OXYGEN IS INTRODUCED AND PRODUCE 

SEVERE BURNS!! USE CAUTION WHEN OPENING THE LID OR DOOR OF THE COOKER.   
 

 

WARNING

:  KEEP THE CONTROL DRY – Allowing the control to get wet can cause damage to 

its electronics and/or make it operate incorrectly CREATING A HAZARDOUS CONDITION.   
 

 

WARNING

: PIT FIRES CAN OCCUR WHEN LIQUIDS ARE SPILLED OR WHEN 

SURFACES INSIDE THE COOKER REACH THE IGNITION TEMPERATURE OF FATS!! Never pour 
or toss water directly into a fat fire. Reduce the temperature by cooling the fire in the firebox with a water 
spray. Close the cooking chamber door and the firebox while it is steaming to smother the fire. Repeat this 
procedure as necessary to get the pit fire under control.  
 

NOTE:

 Pit fires can be largely avoided if the cooker is kept clean and free from fat buildup during or 

between cooks. Changing drip trays during a cook cycle helps keep flammable fats in the cooker to a 
minimum. Keep cooking temperatures low enough to avoid ignition.  
 

 

WARNING

: THERE ARE HOT SURFACES ON ALL PARTS OF THE COOKER BEFORE, 

DURING, AND AFTER COOKING!! Wear protective clothing when tending the pit, attempting to 
extinguish a fire, or dumping a firebox in a proper ash receptacle. Be ready to call your local fire company 
in the case of an emergency situation.

 

 

CAUTION

: Fire danger is always present, even in the best conditions.  Continuously perform 

safety precaution procedures. 

Summary of Contents for PartyQ













Reviews: