3
2x
LED SYS
OK?
LED 1
LED 1
LED 1
LED 1
5.1 Pairing transmitter with receiver
only IN1 of the transmitter(s) will be evaluated
5
Configuration
Press button
Transmitter Tx
Receiver
Receiver
Receiver
Transmitter Tx
Release button
… or wait
1 min.
Long press
button
Long press
button …
Flashes
orange
Green
Release
button
Code saved
Beep
Beep
Beep
7.1 Status output, LED
7
Receiver
6
System test, mandatory after each set-up!
2x
5x
5.3 Clear pairings
All pairings
deleted
Receiver
… or wait
Press button
and hold
Long press
button …
Release
button
Flashes
orange
Beep
Beep
1 min.
5 s
Beep
Green
Red
Press each
safety edge
LED
LED 1
Output 1
Output 1
Buzzer
SYS
3–4
5–6
No power supply
–
–
closed
open
Power up
red
red
closed
open
ends with 4x beep
No sensor paired
green
red
closed
open
System ready, no sensor pressed
green
green
8k2
closed
Sensor pressed (main closing edge)
orange
red
closed
open
Wicket door open (XRF-TW)
orange
red
closed
open
Configuration (Pairing)
orange
flashing
orange
flashing
closed
open
upon action
Configuration, memory full
orange
flashing
orange
flashing
closed
open
10x
Low battery
green
green
8k2
closed
3x every min.
Test input active
green
red
closed
open
Error
a = Broken cable between edge and input, resistor out of range
b = Tx lost or empty battery
c = System error
a = red
b = red
c = red
red
closed
open
(see also manual of transmitter)
Does the door/gate stop when the sensing
element is activated?
5.1.a Bircher signal indicator (BSI)
Details see supplementary sheet
Receiver
Press
button
LED flashing green level of Bircher signal indicator
5.2 Leave configuration mode (always possible)
Beep
