Make sure the enhanced child seat is securely locked in the desired position by
pulling or pushing or pull on the seat body.
Important !
Before making any car journey, ensure that the rotating part of the
enhanced child seat is fully engaged by trying to rotate the enhanced child seat in
both directions.
WARNING:
DO NOT use rearward facing child seat in seating positions where an
active frontal airbag installed . Death or serious injury can occur.
5.4. Putting the child in/ Taking the child out
1. Adjust the rotation handle on the side of the base, rotating the seat body 90°
towards the vehicle door at the same time.
2. Now you can put your child in or take him or her out easily.
3. Secure your child in the seat
4. Rotate the seat body 90° again so it is facing either forwards or backwards,
depending on the age of your child, until it engages with a clicking sound.
Important !
Before every journey, make sure that the rotating seat body is fully
engaged.
5.5. Removing the enhanced child seat
1. Hold and push support leg adjustment handle and slide the lower section into
the upper section of the support leg until it is fully stored .
The ISOFIX connectors are protected against damage once they are pushed
back into the ISOFIX frame of the base.
Important !
The enhanced child seat must always be secured when it is in the
vehicle, even if no child is being transported.
5.6. Maintenance and cleaning
5.6.1. Daily maintenance
1. In daily use, check periodically the enhanced child seat. The enhanced child
seat should be replaced after an accident.
2. Please keep this enhanced child seat in dry and ventilated place to avoid damp
moldy.
3. If the enhanced child seat becomes dusty, clean the seat belt and the plastic
pieces by swiping them with a damp sponge and let it dry under ambiance.
4. If food or drink drop accidently on the buckle, disassemble the seat belt from
the enhanced child seat and rinse it gently by warm water. Leave it dry under
ambiance.
5. For cleaning the entire child seat fabric cover, please refer to the 5.6.2washing i
nstruction.
5.6.2. Washing instruction
Never use any solvant, chemical detergent or lubricant on any part of your child
seat.
30
℃
P
2. Loosen the ISOFIX connectors on both sides by pressing the ISOFIX release
button. at the same time ,move the ISOFIX connectors back into the ISOFIX
frame of the base .
Hand wash, water
temperature below
30
℃
Do not bleach
Dryclean,any
solvent except
trichloroethylene.
Do not tumble dry
Do not iron
