TOYOTA
TUNDRA D-CAB
2004 -
VSE SUBWOOFER (NON-JBL)
Procedure
NOTE:
If the green light on the VSE unit is
NOT illuminated – then the wire harness is not
properly connected to either the radio/amplifier,
or is not properly grounded.
10.
Reassemble Interior
11.
Test and Set Up Procedures
(a)
Gain Control Knob Adjustment
Fig. 11a
Fig. 11b
(1)
Remove gain control knob with needle
nose pliers. (Fig.11a)
(2)
With a small slotted screwdriver, gently
turn the gain control fully
counterclockwise. (Fig.11b)
Fig. 11c
Fig. 11d
LED
(3)
Re-install gain control knob with white
mark at 9:00. (Fig.11c)
(b)
Match up white mark on gain control knob
with mark on enclosure. (Fig.11d)
(c)
If system is installed correctly, the VSE
Subwoofer will power up when the vehicle’s
ignition is turned on. (indicated by
illumination of the POWER L.E.D. on the
Gain Control module of the unit.)
(d)
Using the tone controls on the radio, adjust
the balance left and right, to verify that VSE
Subwoofer produces sound on both sides,
and that the sound is loudest when the
balance is set to the center.
12.
Post Installation
(a)
Clean up and remove any trash.
(b)
If required, wipe down all applicable interior
surfaces with a plastic safe, VDC approved
cleaner. to remove fingerprints, etc
(c)
Place Service Care Card in glove
compartment
(d)
Hang Product Feature Placard onto the
rearview mirror.
Page 8 of 12 pages
Issue: A 12/15/04
