TOYOTA
TUNDRA D-CAB
2004 -
VSE SUBWOOFER (NON-JBL)
Procedure
Fig. 8g
Harness
clip
(g)
Route wire harness along the factory harness
and wire tie as shown. (Fig. 8f & 8g)
Fig. 8f
(1)
Start the wire tie outside the pillar cover
and slide up the harness, tighten to the
existing harness clip and cut off excess.
(h)
Remove rear corner of the rear carpet from
under the driver side pillar cover and route
the wire harness under the cover. (Fig. 8h)
Fig. 8h
(1)
Tuck the carpet back under the pillar
cover.
Fig. 8i
(i)
Using the supplier 10mm bolt, install the
ground ring onto the vehicle accommodated
weld nut. (Fig. 8i)
Fig. 8j
(1)
Torque bolt to 10 lbf
·
ft
(j)
Continue to route the wire harness under the
rear edge of the carpet. (Fig. 8j)
Fig. 8k
(k)
Remove rear corner of the rear carpet from
under the passenger side pillar cover and
route the wire harness under the cover,
toward the passenger side rear door opening.
(Fig. 8k)
(1)
Wire tie the wire harness to the vehicle
harness as described in step
g-1
.
(2)
Tuck the carpet back under the pillar
cover.
(l)
Route the wire harness along existing vehicle
harness in the rear door opening.
Fig. 8l
Carpet clip
(1)
Release the white plastic carpet clip and
route wire harness underneath. (Fig. 8l)
(2)
Fasten to the vehicle harness using (3) 7”
wire ties as shown. Trim excess. (Fig. 8l)
(m)
Route wire harness behind the B-pillar cover
toward the front.
Issue: A 12/15/04
Page 5 of 12 pages
