Page
9
Quick
Start
for
MSPr100
ATS
part
Connect to your unit and type the attention character 5-times at the prompt. You should see the following menu.
At the Prompt Type ‘1’ and press Enter.
You should see a similar screen.
At the prompt type ‘config’ and press Enter
NOTE: None Redundant units do not have options 8 and 9.
Should see the following menu:
At the prompt type ‘8’ and press Enter
Module: 1
Attention Character: ;
MSPr100 ( 2,1).....1
Status......................................S
Configure...................................C
Unit Reset.................................RU
Logout......................................T
Enter Request :
1
Operating Voltage: 120.0 Volts,
Current Active Source: 1
Source 1 RMS Voltage: 121.5
Source 2 RMS Voltage: 121.6
Load RMS Voltage: 121.5
Total kW-h: 33956474
-----------------------------------------------------------------
| Circuit | True RMS | Peak RMS | Average | Volt- |
| Breaker | Current | Current | Power | Amps |
-----------------------------------------------------------------
| CKT1 | 0.1 | 0.3 | 0 | 18 |
-----------------------------------------------------------------
Int. Temp: 97.7 F
Switch 1: Open 2: Open
1)...MOD 1 Outlet 1 : On Locked 2)...MOD 1 Outlet 2 : On Locked
3)...MOD 1 Outlet 3 : On Locked 4)...MOD 1 Outlet 4 : On Locked
5)...MOD 1 Outlet 5 : On Locked 6)...MOD 2 Outlet 1 : On Locked
7)...MOD 2 Outlet 2 : On Locked 8)...MOD 2 Outlet 3 : On Locked
9)...MOD 2 Outlet 4 : On Locked 10)...MOD 2 Outlet 5 : On Locked
Type Help for a list of commands
MSP-100>
config
1)...Manage Users
2)...Change Outlet Name
3)...Enable/Disable Confirmation
4)...Enable/Disable Status Menu
5)...Change Unit ID
6)...Change Alarm Threshold
7)...Change Display Orientation
8)...Change Redundant Power Switch Back mode/time
9)...Change Redundant Power Switching Brownout Voltage Levels
X)...Exit
Enter Request:
8
