Bayne Thinline DTL 1116, Operation And Parts Manual, Page: 19 / 44

Document Number: 1900-0098 Issue Date: 01/15/08 Revision No: 003 Page: 19 of 44
6.
Check the position of the racks in the pinion by making sure both racks seat against the
actuator body at the same time and also when the racks are seated against the body, the
key ways on the pinion shaft should be facing down toward the table and very slightly
back toward the mounting flanges on the actuator body as shown in figure A-6.
figure A-6
7.
Coat one end of the actuator tubes (3) (fig. A-13) around the seal area with STP Oil
Treatment as shown in figure A-7. Using a rubber mallet, drive the coated end of the tube
onto the exposed rack until the tube end seats in the actuator body, making sure that the
seals remain in place as the tube enters the counter-bore. Repeat this procedure for the
other side.
figure A-7