Bayne Thinline BTL 208-12, Operation And Parts Manual

Page: 17 / 38

Document Number: 1999-0212 Issue Date: 06/06/07 Revision No: 005 Page: 17 of 38
4.
Place the actuator body (7) (fig. A-4) on the edge of the table, mounting flanges closest to
the assembler with the counter-bores facing up. Insert the pinion shaft (1) through the bore
on either side of the actuator body with the key ways facing back toward the mounting
flanges and up away from the table with the center line of the key ways pointing in the
position as shown in figure A-4. Center the pinion in the actuator body.
figure A-4
5.
Coat the head portion of the racks (2) (fig. A-13) with STP Oil Treatment. Install the
racks, head portion up with the teeth facing the flanges of the actuator body, into the dual
set of bores in the body. Simultaneously slide the racks into the bores so that the racks
mesh with the pinion in the same position. Rotate the pinion shaft to engage the racks into
the pinion.
figure A-5