Bay Tek Games Big Bass Wheel, Service Manual

Page: 51 / 74

TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE-SCORING ISSUES
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE REMEDY
MOTOR PROBLEMS
AS THE MOTOR STARTS, 5 VOLTS DC IS PRESENT AT THE
CONNECTOR, IT BUILDS TO 12 VOLTS AS THE WHEEL
GAINS SPEED.
TO I/O BOARD:
PHONE CABLES ARE DOUBLED UP FOR REDUNDANCY-
MOTOR WILL STILL WORK WITH ONE WIRE OFF.
MOTOR WILL NOT
ASSIST THE SLOW SPIN
THE GAME SHOULD
ALWAYS TRY TO HELP A
SLOW SPIN.
IT MAY HELP THE
SMALLER CHILDREN
PLAY THE GAME.
ATTRACT MODE:
THE BIG SPINNING
WHEEL MAY HELP
ATTRACT PLAYERS TO
THE GAME.
IF NOT, THE REASONS
CAN BE ANY ONE OF
THESE PROBLEMS
MAKING THE GAME GO
TO "ABANDON GAME".
A. ENTER THE OPERATOR MENU,
ENSURE THE GAME ISN'T SET TO
"ABANDON GAME" UNDER THE
PLAYER TIMEOUT SELECTION.
B. ENTER THE OPERATOR MENU,
CHECK THE DIAGNOSTIC
INFORMATION FOR THE "MOTOR
WATCHDOG" ERROR.
C. DOOR OPEN.
D. FAULTY ENCODER SENSOR.
E. AUTO SPIN CATCH IS BROKEN.
F. DRIVE CHAIN BROKEN.
G. CABLE PROBLEM.
H. I/O BOARD FAULTY.
I. GAME IS SET TO "NEW JERSEY
MODE".
A. CHANGE TO "MOTOR ASSIST".
B. CHANGE "ABANDON GAME" TO "MOTOR
ASSIST". TURN GAME OFF THEN BACK ON TO
CLEAR THE ERROR.
C. THE MOTOR ASSIST WILL NOT ENGAGE IF
THE GAME THINKS A DOOR IS OPEN, CLOSE
ALL DOORS.
D. ASSIST MOTOR WILL TRY FOR 2 SECONDS,
NOT "SEE" THE WHEEL TURNING, AND THEN
DEACTIVATE.
E. INSPECT MECHANISM ON THE LEFT SIDE.
REPLACE SPRING IF NEEDED (A5SREX040).
F. INSPECT DRIVE CHAIN THAT POWERS THE
WHEEL. REPLACE IF NEEDED (A5CH1003).
G. INSPECT THE CABLE FROM THE MOTOR TO
THE I/O BOARD.
H. REPLACE I/O BOARD (AACB1900).
I. NEW JERSEY LAW DOES NOT ALLOW THE
WHEEL TO AUTO-SPIN.
BAY TEK GAMES, INC. BIG BASS WHEEL SERVICE MANUAL Page 51