Bay-tec GR7FA, Instruction Manual

Page: 1 / 5

Bay-Tec Fasst comp. Receiver
GR7FA
Instruction manual
Thank you for purchasing
Bay-Tec
’s GYRO-Embedded FASST compatible receiver. This
production can supply enhancement smooth with FASST link in the flight.
Compatibility:
Bay-Tec
2.4GHz Spread Spectrum FASST Compatible Receiver is designed to use with
FUTABA FASST 2.4GHz transmitters, such as TM7, TM8, TM10, TM14 or T6EX-2.4G, 7C-2.4G, 8FG,
10CG, 12FG,14SG,18MZ
Feature:

Mode supply: No mixer, Dual-aileron, V-tail mixer, Delta mixer

Independent simple gyro gain adjustment for Aileron, Elevator and Rudder

S.BUS output support expanding servo channels.

Support gyro function switch on and off in flying by Switching signal of CH5
Specifications:

Voltage Range :3.6~8.5V

Operating Current: 70mA max

Operation temperature: -10~70 degC

Latency: 14mS @ FASST multi-channel mode /16mS @ FASST 7ch mode

Sensitivity: about -96dBm

Weight: 16g
Bind procedure:

Turn on the FASST transmitter

Connect the battery to the receiver while pressing receiver’s F/S button.

The Dual-color LED’s continuous will cycle through the following:
o
Red LED light (searching radio signal)
o
Green LED light (acquired the radio signal)
o
Red LED off (bind ok)
o
Green LED flashes 10 times (ID store in memory)
o
Green LED lights solid (normally operation)
Installation Guide:

Make sure that your plane has good status before installing GR7FA and other electrical device
on it.

The receiver need to be firmly mounted near the gravity of the plane by double side tape,
refer to illustration below.