28
Adding Units to the Stack
This section describes how to add one or more units to the
middle of a stack or to the end of a stack.
Adding Units to the Middle of a Stack
To add one or more units to the middle of a stack,
complete the following steps:
1.
Determine the position of the new units in the
existing stack (
Figure 12
).
For example, the shaded units (units 5 and 6) in
Figure 12
show two new units to be added to the
stack. The new units are numbered as unit 5 and unit 6
because they are additions to an existing 4 unit stack.
2.
Disconnect the cascade cable from the Cascade A
In connector at unit 3.
Leave the other end of the cascade cable connected to
the Cascade A Out connector at unit 2.
3.
For 19-inch rack configurations, move the units
two spaces lower in the rack.
Note:
Refer to Using the BayStack 450
10/100/1000 Series Switch for information about
installing units on a tabletop or in a standard
19-inch utility rack.
