ESP
FR
ENG
User’s Guide
Check Weight scale
Model Super SS
14
3.9.6 bUZZEr (set buzze)
When menu displays bUZZEr, press TARE to enter, press SET/0~9 to choose “on” or “oFF”, press TARE to
confirm.
3.9.7 Change division figure
When menu displays d, press TARE to enter, press SET/0~9 to choose division.
3.9.8 On-rA (choose range of power on)
When menu displays On-rA press TARE to enter, press SET/0~9 to choose “20” or “100”, “20” is 20% max.
capacity, 100 is 100% capacity. Press TARE to confirm.
3.9.9 d-dP (Choose single or dual display)
When menu displays d-dP, press TARE to enter, press SET/0~9 to choose “n” or “y”, “n” is single display, “y”
is dual display. Press TARE to confirm.
3.10. TUNE LED LIGHTING
On powering on, long time press ZERO/ON, it shows LC-, press SET/0~9 to choose LU-1 or LU-2, LU-1 is
saving mode (commend). Press TARE to confirm.
4. NOTE
1. Not overloading. Not throw heavy things on the scale violently. The damage for overloading is not within the
range of guaranteed maintenance.
2. Don’t use sharp thing to operation the keyboard. if the rubber is damaged it will influence the performance
of waterproof.
3. Keep the scale clean in order to weighing well.
4. There is a lead seal on the bottom of the scale. Users are not allowed to remove the seal. If the seal is da-
maged the scale is not guaranteed for maintenance.
5. a. You must charge the battery at least per 3 months when you don’t use the scale for long time.
b. Please correctly connect line between adapter and battery, black to black, red to red.
c. If after charging the used time becomes short than often, please change a new battery.
5. DIVISION CHANGEMENT
1. Press ON/ZERO to turn on the scale.
2. Press TARE key until the wanted (nXXXX) division appears. When pressing TARE again it returns to the
previous division. The division that it appears on screen is the selected division.
3. The scale automatically returns to the weighing mode.
6. CALIBRATION
This operation can only be done by competent authorized personnel according to the laws of each country.
1.
With the scale turned off, unseal the seal of the division modification switch. This switch is located in the
inferior face of the scale.
2.
To change the position of the switch of division modification.
3.
Press the button ON / ZERO to turn on the scale.
4.
Press the TARE key until “CAL” appears in the screen.
5.
Press the TARE key again, the maximum capacity of the scale will appear.
6.
Locate on the scale the weight of its maximum capacity.
7.
Wait 5 seconds.
8.
Press the TARE key again, the message “CaEnd” will appear in the screen. The calibration has finished and
the scale automatically returns to the weighing mode.
9.
Press the key OFF to turn off the scale.
10.
Locate the switch of division modification to their original position.
11.
Seal the modification switch again.
NOTES: during the calibration, if you want to quit, press ON/ZERO.
Summary of Contents for Super SS
Page 16: ......
