Baxi nuvola3 comfort, Instruction Manual For Users And Fitters

Page: 47 / 72

47
INSTRUCTIONS FOR USERS
71.05086.02 - EN
To keep the boiler efficient and safe, have it checked by the authorised Service Centre at the end of every operating period.
Careful servicing ensures economical operation of the system.
Do not clean the outer casing of the appliance with abrasive, aggressive and/or easily flammable cleaners (e.g.: petrol, alcohol, and
so on). The appliance must not be powered when cleaning (see section 6 “Switching off the boiler”).
10. ROUTINE MAINTENANCE INSTRUCTIONS
ERROR CODE DESCRIPTION OF FAULT CORRECTIVE ACTION
01E Ignition failure
Press OK . If this fault occurs repeatedly, call the Authorised
Service Centre.
02E Safety thermostat tripped
Press OK . If this fault occurs repeatedly, call the Authorised
Service Centre.
03E Flue thermostat/ flue pressure switch tripped Call an Authorised Service Centre
04E Safety error due to frequent flame loss Call an Authorised Service Centre
05E Delivery sensor fault Call an Authorised Service Centre
06E DHW sensor fault Call an Authorised Service Centre
11E
Safety thermostat for low temperature system cuts
in (if connected)
Call an Authorised Service Centre
12E
Differential hydraulic pressure switch block
Check that the pressure in the system is correct. See section
5. If this fault persists, call the Authorised Service Centre.
13E Differential hydraulic pressure switch contact faulty
Check that the pressure in the system is correct. See section
5. If this fault persists, call the Authorised Service Centre.
25E
No water safety trip Call an Authorised Service Centre
31E
Communication error between electronic board and
climate controller Press OK . If this fault occurs repeatedly, call the Authorised
Service Centre.
35E Parasite flame (flame error)
Press OK . If this fault occurs repeatedly, call the Authorised
Service Centre.
80E-96E Internal climate controller error Call an authorised Service centre
98E Internal board error Call an authorised Service centre
99E
Internal board error Call an authorised Service centre
BLOCK
In the presence of a block, the display
shows the symbols
and the
blinking message >>>OK which alter-
nates blinking (about every 2 seconds)
with the <
ERROR > message.
The block is identified by an error
code followed by the letter
E .
Press OK to reset the electronic board
and restore operation.
The display shows the message <
RE-
SET > followed by the letters
>>>OK .
0608_2805
0605_3101
2 seconds