16. FINAL REVIEW
1.
If a gap is visible between the inner sides of the fascia and the ceramic side walls,
gently slide the walls forward.
2.
Visually inspect the appliance. Clean off any marks incurred during installation.
3.
Advise the customer how to operate the appliance. Point out that lighting instruction
details are on the metal plate attached to the burner at the bottom of the appliance.
Explain to the customer that the appliance has a flame failure & spillage monitoring
system. Point out the explanation of this system shown in the owner guide under
“Operating the fire”. Advise that if the fire goes out for any reason, wait at least three
minutes before relighting. Stress that if the monitoring system repeatedly shuts off the
fire, the appliance should be switched off and a specialist should be consulted.
4.
Advise the customer that they should read their owner guide before operating the fire
and always follow the advice in the section headed “Cleaning your fire”.
Stress that no extra ceramic fuel effect pieces must be added over and above those
supplied with the appliance and that any replacements must only be the authorised
spares. Warn that ignoring this advice could cause incomplete clearance of the
products of combustion with consequent health hazards.
6.
Advise the customer that the appliance will operate to its maximum potential if the
flue is primed during the first 20 – 30 minutes of use. To do this, simply turn the control
knob to its highest setting. This will also burn off any carbon deposits that may have
formed during previous use.
If using the appliance for long periods it is beneficial to change between settings. This
will also help to remove any carbon deposits that may form during use.
7.
Recommend that the appliance should be serviced by a competent person at least
annually.
8.
If the appliance is in premises in the United Kingdom occupied by a tenant, point out
that by law a landlord must have any gas appliance, flue and pipework which is situated
in a tenant’s premises checked for safety at least every 12 months.
9.
Advise that the fire may give off a slight odour while new. This is quite normal and
it will disappear after a short period of use.
10.
Inform the customer that the Serial number for the appliance is located on the
data label located behind the lower front casting and attached underneath the
burner module.
11.
Hand the literature pack with this guide to the customer.
Page 30
INSTALLER GUIDE
