7.
Place the remaining type “A” coal
between the front and rear base coals.
The letter “A” should be upside down
with its rear face between the right
and centre coals of the rear base coal.
Angle the coal so that the gap
between it and the type “B” coal to its
right is appreciably larger than the
gap between it and the type “A” coal
to its left but do not have it touching the type “A” coal. This will give the best flame
effect. See figure 10.
FUEL BED REFITTING - CERAMIC PEBBLES
This section is for models supplied with ‘Pebbles’ effect fuel bed only.
For ‘Coal fuel bed’ see section ‘Fuel bed refitting - ceramic coals’
1.
Place the rear base pebble in the firebox. It
should rest on the ledges at the rear sides of the
burner unit. When located gently move the rear
base pebble so that it is as far forward as possible.
The amount of movement will be negligible (See
figure 11).
2.
Place the front base pebble in the firebox with its
bottom front locating over the front rim of the
firebox. Pull the pebble forward so that it locates
immediately behind the front rim of the firebox.
(See figure 12).The front base coal will touch
the rear base coal as it is located.
Page 12
OWNER GUIDE
Figure 10.
Figure 12 Front Base Pebble
Position
Figure 11 Rear Base Pebble
Position
