12.4 Fitting the magntic three piece fascia
trim.
1.
The fascia is supplied in three pieces.
Carefully remove the three pieces from the
packaging. Remove any protective film.
2.
The magnets used to locate each trim should
already be positioned on the rear of each trim.
Each trim should have two magnets. If the
magnets are not fitted then locate one magnet
centrally at each end of the trims.
3.
Locate the side trims as in figure 28.
4.
Locate the top trim as in figure 28.
12.5 Fitting the Blenheim, Capri, Sonnet,
Traditional, Homeflame Slimline
Traditional, Debut, Prelude, Flare &
Coast firefront.
1.
Place the firefront / casting on top of the
hearth centrally between the fascia.
2.
On models with a two piece firefront
place the lower front cover casting / ash pan
below the front casting. For the ‘Coast’
model see figure 29.
12.6 Fitting the Aura 2, Minima, Form,
Seattle & Camden firefront.
1.
Place the firefront on top of the hearth
centrally between the fascia.
12.7 Fitting the Anthem firefront.
1.
The Anthem firefront is fitted with a set of
fixing brackets. Each bracket has two threaded
holes. As supplied the top threaded hole should be
fitted with a 25mm long machine screw. If the
screw has been located to the threaded hole
below, remove it and locate to the hole above.
2.
The screw should be set at a distance of 15mm
(Measured from the surface of the bracket to the
underside of the screw head). Adjust the screw to
this distance (See figure 30).
Page 30
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 30. Bracket location
Figure 29. Coast firefront location
Figure 28. Fitting the magnetic fascia
