8. FITTING THE FIREFRONT
8.1
For models NOT supplied with a Firefront.
A slotted firefront with a
minimum
free area as shown in figure 12 must always be
used.
8.2 For models SUPPLIED with a firefront.
The firefront supplied with this fire has been tested and found to be satisfactory for use
with this fire. The open area may differ slightly from that shown in figure 12.
Place the decorative firefront on the hearth and central to the appliance.
‘Quattro’ / ‘Anthem’ firefront only
1.
The Quattro / Anthem firefront is fitted with
a set of fixing brackets. Each bracket has two
threaded holes. As supplied the top threaded
hole should be fitted with a 25mm long
machine screw. Remove the machine screw and
locate to the threaded hole below.
2.
The screw should be set at a distance of
7mm (Measured from the surface of the bracket
to the underside of the screw head). Adjust the
screw to this distance (See figure 13).
Page 19
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 12. Firefront minimum open area requirements
Figure 13. Bracket locations
