10.
The sides have a stepped top face. These
must be located on the inside the top piece (See
point 1 of figure 14). The tabs on the top piece
must locate on the inside of the side pieces (See
point 2 of figure 14). Secure the two side pieces
to the top piece using two self tapping screws
supplied. Locate the screws from inside the ‘U’
channel.
11.
There is a length of self adhesive foam seal
supplied with the fire. This will need to be fitted
to the outer rear edges of the side and top
pieces of the spacer frame. Fit it to the
flanges that do not have holes. The holes
must be placed against the rear of the fire.
Ensure that there is no gap between the
foam seals where they meet at the top
flange (See figure 15).
12.
Locate the spacer frame to the rear of
the hotbox
(The foam seal must be to the
rear of the spacer frame and NOT
against the flanges of the hotbox)
. Secure
the spacer frame to the hotbox using the six
edge clips supplied. Position these as in
figure 16.
13. Remove any protective film from the spillage
plate.
Page 17
INSTALLER GUIDE
Figure 16. Fitting the edge clips
Figure 15. Fitting the foam seal
Figure 14. Fitting the foam seal
