Page 4
ZR-DC/WBX
Installation and Operating Instructions
PRODUCT SAFETY
Please follow these instructions as you install your ZR-DC/WBX and retain them for its lifetime. If you encounter any
problems contact Baxall Limited.
IMPORTANT NOTE
The power supplies in your ZR-DC/WBX receiver are designed to power the receiver itself and to provide outputs for
lens drives, pan and tilt drives etc. Under no circumstances should any other equipment such as cameras, heaters,
fans, interface converters etc. derive their power directly from your ZR-DC/WBX receiver. Incorrect use of the
receiver in this manner may cause damage and invalidate your warranty.
Installation is only to be carried out by competent, qualified and experienced personnel. Wire in accordance with the
country of installations National Wiring regulations. Failure to do so can result in death or injury by electric shock. A
means of disconnecting the receiver from the mains supply must be provided as part of the installation and must be
situated close by.
BEFORE UNDERTAKING ANY INSTALLATION OR MAINTENANCE, THE RECEIVER MUST BE DISCONNECTED FROM THE
MAINS SUPPLY.
Your ZR-DC/WBX is designed for use in a general purpose CCTV installation and has no other function. Do not exceed
the voltage and temperature limits given in the specifications. Only use your ZR-DC/WBX in a clean, dry, dust-free
environment unless a suitable protective housing is provided.
To prevent access by unauthorised personnel, tighten the four lid securing screws on the weatherproof enclosure
with a suitable tool until they cannot be undone by hand. Do not exceed a torque of 4Nm.
ELECTROMAGNETIC COMPATIBILITY (EMC)
This is a Class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
This product is intended solely for use in general purpose CCTV applications.
The product must be installed and maintained in accordance with good installation practice to enable the product to
function as intended and to prevent problems. Refer to Baxall Limited for installation guidance.
MANUFACTURERS DECLARATION OF CONFORMANCE
The manufacturer declares that the equipment supplied with this manual is compliant with the essential protection
requirements of the EMC directive 89/336 and the Low Voltage Directive LVD 73/23 EEC. Conforming to the requirements
of standards EN 55022 for emissions, IEC801 parts 2, 3 and 4 for immunity and EN 60950 for Electrical Equipment
safety.
