Page 14
ZR-DC/WBX
Installation and Operating Instructions
TESTING THE PAN/TILT HEAD, LENS AND PRESETS
The Test Button shown in figure 1 controls the 14 tests. Push and release the button once to enter test 0. Push and
release again to increment through each of the tests. The receiver will automatically leave test mode 30 seconds after the
last depression of the push-button or after Test 13. While you are in test mode, the Telemetry and Video Status LED
remains lit.
Test Number
Action
Test Number
Action
Test 0
Pan Left
Test 9
Wipe
Test 1
Pan Right
Test 10
Camera
Test 2
Tilt Up
Test 11
Lamps
Test 3
Tilt Down
Test 12
Aux 4
Test 4
Zoom Out
Test 13
Preset 1
Test 5
Zoom In
Test 14
Preset 2
Test 6
Focus Out
Test 15
Preset 3
Test 7
Focus In
Test 16
Preset 4
Test 8
Wash
TESTING THE PAN/TILT HEAD, LENS AND PRESETS
It is only necessary to test one of the preset positions to ensure that the feedback connections are correct. If they are not
then they can be changed by using switches 6, 7, and 8 according to the next section.
SETTING UP THE PRESETS
Most Baxall transmitters access and set the presets by the following method, however on some transmitters the presets
can be accessed directly (see your transmitter manual).
1. Move the pan/tilt head to the desired position for this preset.
2. Store the position as preset <n> using the appropriate method for the transmitter or keyboard being used. This is
normally done by pressing the following keys in sequence:
F
(the function key), <n> (a number for the preset
between 1 and 8), (the preset key).
3. Further preset positions may be stored by repeating step 2 above.
4. Preset positions are recalled using the appropriate method for the transmitter or keyboard being used. This is
normally done by pressing the number of the preset position to be recalled followed by the preset key.
5. Programmed presets can be easily verified by activating the corresponding alarm input, e.g. activating alarm input 5
will recall preset 5.
A link on the preset board (the 2 pin jumper CON 4 shown in figure 1) allows you to disable the presets. When the jumper
is shorted, the presets are disabled.
FUSE REPLACEMENT
ZR-DC/WBX - Supply fuses
The two separate incoming live supply connections are independently fused.
The fuse characteristics are clearly
marked on the label adjacent to the supply terminals. When replacing or removing both fuses, ensure that the two
fuses are not inadvertently refitted in the incorrect supply line. If either should fail, the fuse must be replaced with one
of identical value and characteristics as follows
.
1. DISCONNECT THE SUPPLY.
2. Pull the appropriate black plastic fuse holder from the terminal block which is fixed to the metal baseplate.
3. Replace the fuse with the correct type and value.
4. Replace the fuse holder and reconnect the supply.
